LAB GRUPPEN LUCIA 60/2M เพาเวอร์แอมป์ 2 แชนแนล 30 วัตต์


LAB GRUPPEN LUCIA 60/2M เป็นแอมป์แบบ 2 แชแนล มีกำลังขับ 30 วัตต์ ที่ 8 และ 4 โอมห์



[ กรุณาโทรสอบถามสต๊อกสินค้าก่อนทำการสั่งซื้อ ]

สั่งซื้อผ่านไลน์ @siamsoundstore
หมวดหมู่: , , ป้ายกำกับ: Brand: LAB.GRUPPEN


LAB GRUPPEN LUCIA 60/2M เพาเวอร์แอมป์ 2 แชนแนล 30 วัตต์

LAB GRUPPEN LUCIA 60/2M เพาเวอร์แอมป์ 2 แชนแนล 30 วัตต์

  • Maximum output power across range of loads – 2 x 30 W into 8 4 or 2 ohms
  • Comprehensive DSP features – Per channel presets for high-pass filter parametric EQ delay and look-ahead limiter
  • Automatic Dynamic Loudness Contouring™ – DSP automatically adapts to optimize performance at any output level
  • Optimized presets – Available for specific loudspeaker models
  • Auto Load Sense™ – Proprietary auto-set VPL™ (Voltage Peak Limiter) for optimum performance with any connected load
  • 4 x 4 mix matrix – Route input signals internally to either or both amplifier channels
  • Configuration software – Windows and Mac software wizard for initial set-up and advanced editor for preset configuration (LUCIA connection via USB)
  • RS232 – Remote control and monitoring from third party control solutions
  • GPIO – Remote control (e.g. wall panel) for channel switching level control and integration with paging systems
  • Compact form factor – Half-rack 1U chassis and supplied bracket for discreet on-wall mounting (e.g. behind display screens)
  • Efficient Class D amplifier – Patented design for low distortion and minimal heat dissipation
  • Fail-safe operation – Comprehensive short circuit thermal and under-voltage protection
  • Universal power supply – Operates at 100 – 240 V AC (50 or 60 Hz)
  • ENERGY STAR® qualified – Conforms to latest specification energy efficiency standard
  • Intelligent fan control – Silent operation at idle and at lower output levels

ดูสินค้ายี่ห้อ LAB GRUPPEN ทั้งหมด




Number of amplifier channels 2
Max total output all channels driven 60 W
Max output voltage per channel 21.9 V peak
Max output current per channel 3.9 Arms
Max output power (all channels driven)
2 ohms 30 W
4 ohms 30 W
8 ohms 30 W
16 ohms 15 W
THD 20 Hz – 20 kHz at 1 W into 8 ohms <0.3%
THD at 1 kHz and 1 dB below clipping <0.2%
Signal to Noise Ratio >95 dBA
Channel separation (Crosstalk) at 1 kHz >60 dBA
Frequency Response 5 Hz – 22 kHz
Input impedance 10 kOhm
Common Mode Rejection (CMR) 40 dB
Gain Sensitivity and Limiters
VPL for 16 ohm mode 21.9 V peak
VPL for 8 ohm mode 21.9 V peak
VPL for 4 ohm mode 15.5 Vpeak
VPL for 2 ohm mode 11 Vpeak
Sensitivity balanced input 4 dBu / 1.23 Vrms
Sensitivity RCA input -2 dBu / 0.62 Vrms
Input headroom for clip balanced 1 12 dBu / 3.09 Vrms
Input headroom for clip RCA 1 6 dBu / 1.55 Vrms
Connectors and Buttons
Output connectors (per ch.) 2 – pin detachable screw terminals
Line-level output connectors (ch. 3 & 4) 3 – pin detachable screw terminals electronically balanced
GPI (power control input) 2 2 channels of voltage sense type. 4 pins in a detachable screw terminal. Default for gain.
Input connectors (per ch.) 3 – pin detachable screw terminals electronically balanced
Input connectors (ch. 1 & 2) Unbalanced RCA type
USB For firmware update and configuration with the Application Browser software
Level adjustment (per channel) Front panel potentiometer detented from -inf to 0 dB
Processing Features
Input processing block 3 4 EQ sections per input
Mix matrix routing block 3 4 in – 4 out mix-matrix controllable from GPI
Output processing block 3 4 EQ sections per output (presets available for many loudspeakers)
User adjustable output look ahead limiter
ADLC (Adaptive ISO 226 compensation)
Two line level outputs 4 Each capable of driving 10 LUCIA devices in parallel
Latency from any input to any output User adjustable from 9.15 to 137 ms
Nominal voltage 100 – 240 VAC
Operating voltage 85 – 265 VAC
Mains connector IEC inlet
Cooling One fan no filter required front to rear airflow temperature controlled speed. Can stay off if the sustained power average stays below 2 × 6 W and the ambient temperature is below 25 C
Auto mode The power state is controlled automatically by the audio signal
Dimensions W: 216 mm (8.5”) H: 44 mm (1 U) D: 280 mm (11”)
Weight 1.9 kg (4.2 lbs)
Finish Black aluminum front and black steel chassis
Approvals CE CSA CCC PSE FCC Energy Star


  • 1: An analog soft limit will be engaged on the input above this level to reduce the clip distortion
  • 2: Can be configured for different functionality such as RS232 via USB.
  • 3: DSP settings determined by settings downloaded from the Application Browser software; not configurable on the unit itself
  • 4: Noise levels typically allow daisy chaining of 3 LUCIA amplifiers without issues